A magnesium-containing wrought sheet alloy used for decorative architectural panels and anodized finishes; Fairview documents its H34 panel material.
Selected H34 panel facts only; single manufacturer source; source calls numerical data typical despite its requirements heading.. Keep typical values, source minima and composition limits distinct. Reference records are not certificates or design allowables.
Grade, forms and temper conditions
5000 series · Sheet and plate
Reviewed temper examples: H34. These do not establish every possible alloy-form-temper supply combination.
Physical properties
Numerical physical properties are not verified for this record and remain withheld.
| Temper | Product form | Thickness / specimen condition | Tensile MPa | Yield MPa | Basis | Source ID |
|---|---|---|---|---|---|---|
| H34 | Sheet / plate panel | Source availability: .080, .090, .125 inch; property table does not allocate values by gauge | 159 | 131 | typical | fairview5005 |
H34 / Sheet / plate panel: Published VitraPlate reference values; source expressly disclaims maximum/minimum specification or final-design interpretation; converted and rounded from source psi values; checked 2026-10-14.
| Element | Minimum wt % | Maximum wt % | Source ID |
|---|---|---|---|
| Mg | 0.5 | 1.1 | fairview5005 |
| Si | — | 0.3 | fairview5005 |
Fabrication and material selection
The reviewed panel source describes H34 material; qualify the finish and supplied gauge for the project. Published typical strengths do not replace an ordered specification or lot certificate.
Applications and product forms
Architectural panels, Decorative anodized components
Standards and acceptance
Identify the governing product specification by the actual form and manufacturing route. A grade designation alone does not establish compliance or equivalence. Confirm the edition, required condition, inspection and dimensional limits through the supplier and an authorized specification.
Product-specific standard scopes · Compare material conditions · Engineering calculators
Technical questions
Are typical values delivery limits?
No. A typical reference value describes the source condition; it is not a guaranteed minimum for a delivered lot.
Which temper and thickness should I compare?
Compare the same material form, temper, thickness/test condition, unit and value basis. Different conditions cannot be silently treated as interchangeable.
Technical sources and verification
Selected reference facts checked 14 October 2026. Source values apply to their stated material condition and are not certification of supplied stock.
- Fairview • VitraPlate 5005-H34 — 2016 copyright; no explicit revision
