A moderate-strength rolled alloy documented by Hulamin for roofing, cladding and signage, with mill, painted and embossed finishes.
Selected rolled-product facts; single manufacturer source; thickness scope of mechanical table not stated.. Keep typical values, source minima and composition limits distinct. Reference records are not certificates or design allowables.
Grade, forms and temper conditions
3000 series · Rolled products
Reviewed temper examples: H14, H32, H34, H42, H44, H46. These do not establish every possible alloy-form-temper supply combination.
| Property | Value | Unit | Temper / form | Condition | Basis / verification | Source ID |
|---|---|---|---|---|---|---|
| Density | 2.72 | g/cm³ | Not specified / Rolled products | 20 °C | source-reference / single-source | hulamin3004 |
| Temper | Product form | Thickness / specimen condition | Tensile MPa | Yield MPa | Basis | Source ID |
|---|---|---|---|---|---|---|
| H14 | Rolled products | Not stated in source mechanical table | 220–265 | 180 | source-minimum-and-range | hulamin3004 |
H14 / Rolled products: Supplier reference: proof stress minimum and tensile range; no thickness or test-direction detail supplied; checked 2026-10-14.
| Element | Minimum wt % | Maximum wt % | Source ID |
|---|---|---|---|
| Mn | 1 | 1.5 | hulamin3004 |
| Mg | 0.8 | 1.3 | hulamin3004 |
Fabrication and material selection
Select the finish and temper for the fabrication route. Hulamin identifies suitability for roll forming and coating; its strength table does not state a thickness band, so confirm the ordered gauge and certificate.
Applications and product forms
Roofing and cladding, Signage, General engineering
Standards and acceptance
Identify the governing product specification by the actual form and manufacturing route. A grade designation alone does not establish compliance or equivalence. Confirm the edition, required condition, inspection and dimensional limits through the supplier and an authorized specification.
Product-specific standard scopes · Compare material conditions · Engineering calculators
Technical questions
Are typical values delivery limits?
No. A typical reference value describes the source condition; it is not a guaranteed minimum for a delivered lot.
Which temper and thickness should I compare?
Compare the same material form, temper, thickness/test condition, unit and value basis. Different conditions cannot be silently treated as interchangeable.
Technical sources and verification
Selected reference facts checked 14 October 2026. Source values apply to their stated material condition and are not certification of supplied stock.
- Hulamin • 3004 rolled products — Undated public datasheet
